Lincoln Electric IM988 SAE500 - Manual (Page 22)

D-3 MAINTENANCE D-3
SAE-500™
GFCI RECEPTACLE TESTING AND RESET-
TING PROCEDURE
The GFCI receptacle should be properly tested at least
once every month or whenever it is tripped. To proper-
ly test and reset the GFCI receptacle:
• If the receptacle has tripped, first carefully remove
any load and check it for damage.
• If the equipment has been shut down, it must be
restarted.
• The equipment needs to be operating at high idle
speed and any necessary adjustments made on the
control panel so that the equipment is providing at
least 80 volts to the receptacle input terminals.
• The circuit breaker for this receptacle must not be
tripped. Reset if necessary.
• Push the "Reset" button located on the GFCI recep-
tacle. This will assure normal GFCI operation.
• Plug a night-light (with an "ON/OFF" switch) or other
product (such as a lamp) into the GFCI receptacle
and turn the product "ON".
• Push the "Test" button located on the GFCI recepta-
cle. The night-light or other product should go "OFF".
• Push the "Reset" button, again. The light or other
product should go "ON" again.
If the light or other product remains "ON" when the
"Test" button is pushed, the GFCI is not working prop-
erly or has been incorrectly installed (miswired). If your
GFCI is not working properly, contact a qualified, certi-
fied electrician who can assess the situation, rewire the
GFCI if necessary or replace the device.
ENGINE AND COMPRESSOR MAINTENANCE
COMPONENTS
ITEM MAKE PART NUMBER
Engine Air Filter Donaldson P822768
Fan Belt Kubota 1G517-97011
Fuel Filter Element Kubota 16631-43562
Engine Oil Filter Kubota 1C020-32433
Cartridge
SPARK ARRESTOR
• Spark Arrester and Muffler may be
hot!
• Allow engine to cool before servicing
spark arrester!
• Do not operate engine while servicing
spark arrester!
------------------------------------------------------------------------
SAE-500™ with integral spark arresting mufflers:
Service spark arrester every 250 hours.
Service as follows:
1. Stop engine and allow to cool.
2. Remove clean out plug from side of spark arrester.
3. Without damaging the spark arrester, gently tap on the
arrester shell near the clean out plug.
4. Once particles are removed, replace the clean out plug.
WARNING