Lincoln Electric IM754 RED-D-ARC ZR-10 - Manual (Page 17)

B-4 OPERATION B-4
WIRE FEED WELDING PROCESSES
(Constant Voltage)
The only Innershield ® electrode recommended for use
with the ZR-10 is NR ® -211-MP. The electrode sizes
and welding ranges that can be used with the ZR-10
are shown in the following table:
The ZR-10 is recommended for limited “MIG” welding
(GMAW - gas metal arc welding). The recommended
electrodes are .030” and .035” L-50 and L-56. They
must be used with a blended shielding gas such as
C25 (75% Argon - 25% CO
2
). The welding ranges that
can be used with the ZR-10 are shown in the following
table:
ZR-10
Diameter Wire Speed Approximate
(in.) Range In./Min. Current Range
.035 80 - 110 75A to 120A
.045 70 - 130 120A to 170A
.068 40 - 90 125A to 210A
Diameter Wire Speed Approximate
(in.) Range In./Min. Current Range
.030 80 - 110 75A to 120A
.035 70 - 130 120A to 170A
SUMMARY OF WELDING PROCESSES
CONTROL ELECTRODE
CABLE IDLE WHEN NOT TO START
PROCESS USED MODE WELDING WELDING
STICK No AUTO Hot Touch electrode to work.
Welding starts immediately
and engine goes to high
idle.
TIG/K7930-1/K938-1, Yes HIGH Cold Press Amptrol, contactor
K936-( ) /K892-1 closes, welding
(WITH AMPTROL) starts immediately.
WIRE FEED, LN-25 WITH No AUTO Cold Press gun trigger, LN-25
INTERNAL CONTACTOR contactor closes. Welding
starts immediately and
engine goes to high idle.
NOTE : Output Control
must be set above “3”.
WIRE FEED, LN-7 WITH Yes HIGH Cold Press gun trigger,
K240 CONTACTOR KIT contactor closes. Welding
starts immediately.