Lincoln Electric IM784 PRO 100 - Manual (Page 9)

A-2 INSTALLATION
PRO 100
A-2
Read entire installation section before starting
installation.
SAFETY PRECAUTIONS
IDENTIFY AND LOCATE
COMPONENTS
If you have not already done so, unpack the PRO 100
from its carton and remove all packing material
around the PRO 100. Remove the following loose
items from the carton (see Figure A.1):
1. PRO 100
2. Gun and cable assembly (1)
3. Literature and miscellaneous including:
a) This operating manual
b) Extra .035" contact tip
c) Hex key wrench for removal of drive roll.
4. 10 ft (3,0 m) work cable.
5. Work clamp.
6. Sample spool of Innershield .035" (0,9 mm)
NR-211-MP electrode.
7. Handshield with filter plate and lens.
8. Instructional video.
For available options and accessories refer to the
Accessories Section of this manual.
(1) The gun is ready to feed 0.035" (0,9 mm) Inner-
shield wire.
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the PRO 100 Operating Manual
should install and operate this equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The PRO 100 power switch is to be in the
OFF (“O”) position when installing work
cable and gun and when connecting power
cord to input power.
WARNING
FIGURE A.1
PRO 100
1
2
3
4
6
7
8
5