Lincoln Electric IM746 POWER WAVE 405 - Manual (Page 11)

A-2 INSTALLATION
POWER WAVE 405
A-2
SELECT SUITABLE LOCATION
The Invertec POWER WAVE 405 will operate in harsh
environments. Even so, it is important that simple pre-
ventative measures are followed in order to assure
long life and reliable operation.
• The machine must be located where there is free cir-
culation of clean air such that air movement in the
back, out the sides and bottom will not be restricted.
• Dirt and dust that can be drawn into the machine
should be kept to a minimum. Failure to observe
these precautions can result in excessive operating
temperatures and nuisance shutdown.
• Keep machine dry. Shelter from rain and snow. Do
not place on wet ground or in puddles.
• DO NOT MOUNT OVER COMBUSTIBLE SURFACES.
Where there is a combustible surface directly
under stationary or fixed electrical equipment,
that surface shall be covered with a steel plate at
least .06
” (1.6mm) thick, which shall extend not
less than 5.90 ” (150mm) beyond the equipment on
all sides.
-----------------------------------------------------------------------
STACKING
POWER WAVE 405 cannot be stacked.
TILTING
Place the machine directly on a secure, level surface
or on a recommended undercarriage. The machine
may topple over if this procedure is not followed.
INPUT AND GROUNDING CONNECTIONS
• Only a qualified electrician should connect the
Invertec POWER WAVE 405. Installation should be
made in accordance with the appropriate National
Electrical Code, all local codes and the information
detailed below.
• When received directly from the factory, multiple
voltage machines are internally connected for
400VAC. If 400VAC is the desired input, then the
machine may be connected to the power system
without any setup required inside the machine.
SAFETY PRECAUTIONS
ELECTRIC SHOCK can kill.
• TURN THE INPUT POWER OFF AT
THE DISCONNECT SWITCH BEFORE
ATTEMPTING TO CONNECT OR DIS-
CONNECT INPUT POWER LINES,
OUTPUT CABLES, OR CONTROL CABLES.
• Only qualified personnel should perform this
installation.
• Connect the green/yellow lead of the power
cord to ground per U.S.National Electrical
Code.
----------------------------------------------------------------------
WARNING
• Initial 200VAC - 230VAC operation will require an
Input voltage panel setup.
• Open the access panel on the rear of the machine.
• For 200 or 230: Position the large switch to 200-
230.
For higher voltages: Position the large switch to
greater than 380.
• Move the "A" lead to the appropriate terminal.
POWER CORD CONNECTION
A 5 meter power cord is provided and wired into the
machine. Follow the power cord connection instruc-
tions.
• Incorrect connection may result in equipment
damage.
-----------------------------------------------------------------------
Single Phase Input
Connect green/yellow lead to ground per National
Electrical Code.
Connect blue and brown leads to power.
Wrap black lead with tape to provide 600V insulation.
Three Phase Input
Connect green/yellow lead to ground per National
Electric Code.
Connect black, blue and brown leads to power.
UNDERCARRIAGE MOUNTINGS
W AR NING W ARN IN G AVIS O D E PRE CA UCIO N
ATTEN TIO N
!
!
!
!
Lor em ipsu m d olo r s it a me t con sec tetu er a dip iscin g
Lore m ip sum do lor sit a me t co nse cte tue r ad ipis cing elit, e d d iam no n elit, ed dia m n onu mm um my n ibh eu ism od tin cid unt ut y n ibh euis mo d tin cidu nt u t lao ree t do lore m agn a al iqu am er lao ree t do lore ma gna aliq uam erat at Lo rem ips um do lor sit a me t con sec tetu er a dip iscin g
Lore m ip sum do lor s it a me t co nse cte tue r ad ipis cing elit , ed dia m n on elit, ed dia m n onu mm um my nib h e uis mod tin cid un t ut y n ibh eu ism od t incid unt ut lao ree t dol ore m agn a a liqu am er lao ree t do lore m agn a a liqu am era t at Lore m ips um dolo r sit am et c ons ec tetu er a dip iscin g
Lore m ip sum do lor sit a me t co nse cte tue r ad ipis cing elit, ed dia m n on elit, ed d iam non um m um my n ibh euis mo d tin cid unt ut y n ibh eu ism od t incid unt ut lao ree t d olo re m agn a aliq uam er lao ree t do lore m agn a a liqu am era t at Lore m ipsum dol or s it a me t co nse cte tue r a dip iscin g
Lore m ip sum dolo r sit am et c ons ecte tue r ad ipis cing elit, e d d iam non elit, ed dia m n onu mm um my n ibh eu ism od tinc idu nt u t y n ibh eu ism od t incid unt ut lao reet dolo re ma gn a al iqu am er lao ree t do lore ma gna aliq uam era t at Lor em ips um do lor sit a met co nse cte tuer ad ipis cin g
Lore m ipsu m d olo r sit am et c ons ecte tue r ad ipis cing elit, ed d iam no n elit, ed dia m n onu mm um my n ibh eu ism od ti nc idu nt u t y n ibh eu ism od t incid unt ut la ore et do lore m agn a a liq ua m e r lao ree t do lore m agn a a liqu am era t at Lore m ip sum do lor s it a me t co nse cte tuer ad ipis cing Lore m ip sum do lor s it a me t co nse cte tue r ad ipis cing elit, ed d iam non elit, ed dia m non um m um my n ibh eu ism od ti ncid unt ut y n ibh euis mo d tin cidu nt u t laor ee t d olo re m agn a a liqua m er lao ree t do lore m agn a a liqu am era t at Lore m ip sum dolo r s it a me t con se cte tue r ad ipisc ing Lore m ip sum do lor s it a me t co nse cte tue r ad ipis cing elit, ed dia m n on elit, ed dia m n onum m um my nib h e uism od ti ncid unt ut y n ibh euis mo d tin cidu nt u t lao ree t d olo re m agn a a liqu am er lao ree t do lore m agn a a liqu am era t at Lo rem ip sum dol or s it a me t c ons ect etu er a dip iscin g
Lore m ip sum do lor s it a me t co nse cte tue r ad ipis cing elit , e d d iam non elit, ed dia m n onu mm um my nib h e uis mo d tin cidu nt u t y n ibh euis mo d tin cidu nt u t lao ree t d olo re ma gna aliq uam er lao ree t do lore m agn a a liqu am era t at Lor em ip sum do lor sit a me t co nse cte tue r ad ipis cin g
Lore m ip sum do lor s it a me t co nse cte tue r ad ipis cing elit, ed d iam no n elit, ed dia m n onu mm um my nib h e uism od tin cidun t ut y n ibh eu ism od t incid unt ut lao ree t do lore ma gna aliq ua m er lao ree t do lore ma gna aliq uam era t at
Lo rem ip sum dolo r sit a me t co ns ecte tue r ad ipis cin g
Lore m ip sum do lor s it a me t co nse cte tue r ad ipis cing elit, ed dia m n on elit, ed dia m n onum m um my nib h eu ism od tin cid unt ut y n ibh eu ism od t incid unt ut lao ree t d olo re m agna aliq uam er lao ree t do lore m agn a a liqu am era t at Lorem ipsum dolo r s it a me t co nsect etu er a dip iscin g Lore m ipsu m d olo r sit am et c ons ecte tue r ad ipis cing elit, e d d iam no n elit, ed dia m n onu mm um my nib h eu ism od t incid unt ut y n ibh eu ism od t incid unt ut lao ree t do lore m agn a a liq uam er lao ree t do lore m agn a a liqu am era t at Lo rem ip su m d olo r sit am et c ons ecte tue r ad ipis cin g
Lore m ipsu m dolo r sit am et c ons ecte tue r ad ipis cing elit, e d d iam non elit, ed dia m n onu mm um my n ibh eu ism od tin cid unt u t y n ibh eu ism od t incid unt ut la ore et d olo re ma gna a liqua m e r lao ree t do lore m agn a a liqu am era t at Lore m ipsu m d olo r sit a me t c ons ecte tue r a dip iscing Lore m ip sum do lor s it a me t co nse cte tue r ad ipis cing elit, ed di am no n elit, ed dia m n onu mm um my n ibh eu ism od t incid unt u t y n ibh euis mo d tin cidu nt u t la ore et d olo re m agn a a liq uam er lao ree t do lore m agn a a liqu am era t at Lorem ips um d olo r sit am et c ons ecte tue r a dipis cing
Lore m ip sum do lor s it a me t co nse cte tue r ad ipis cing
elit, ed diam no n elit, ed dia m n onu mm um my n ibh euism od tinc idu nt u t y n ibh eu ism od t incid unt ut
la oree t d olo re m ag na a liqua m e r lao ree t do lore ma gna aliq uam era t at Lore m ip sum do lor sit am et c on sec tetu er adip isc ing
Lore m ip sum do lor s it a me t co nse cte tue r ad ipis cing
elit, ed d iam non elit, ed dia m n onu mm um my n ibh euis mo d t incid unt ut y n ibh eu ism od t incid unt ut
laor eet do lore m agn a a liqu am er lao ree t do lore m agn a a liqu am era t at Lore m ip sum do lor s it a me t con se ctetu er a dip isc ing
Lore m ip sum do lor s it a me t co nse cte tue r ad ipis cing
elit , ed dia m n on elit, ed dia m n onu mm um my n ibh e uis mod tinc idu nt u t y n ibh eu ism od t incid unt ut
lao ree t dolo re m agn a aliq uam er lao ree t do lore m agn a a liqu am era t at Lore m ipsu m d olo r sit a me t con sec tet uer adip iscing
Lore m ip sum do lor s it a me t co nse cte tue r ad ipis cing
elit, e d dia m n on elit, ed dia m n onu mm um my n ibh e uism od tinc idun t ut y n ibh eu ism od t incid unt ut
laoree t d olore m agn a aliq uam er lao ree t do lore ma gna aliq uam erata t
Lor em ip sum dolo r sit am et co nse ctet ue r ad ipis cing Lore m ip sum do lor s it a me t co nse cte tue r ad ipis cing elit, ed dia m no n elit, ed dia m n onum m um my nib h e uis mo d tin cid unt ut y n ibh euis mo d tin cidu nt u t laor eet dolo re m ag na aliq ua m er lao ree t do lore m agn a a liqu am era t at Lore m ip sum do lor s it a me t co nse cte tuer ad ipis cin g
Lore m ip sum do lor s it a me t co nse cte tue r ad ipis cing elit, e d d iam no n elit, ed dia m n onu mm um my n ibh eu ism od tin cid unt ut y n ibh eu ism od t incid unt ut lao ree t d olo re m agna aliq uam er lao ree t do lore m agn a a liqu am erata t
W ARNING RE M OT E
PO WER
OFF
ON
P O W E R W A V E 3 5 5
GREEN / YELLOW
BLUE
BLACK
BROWN
5.50
10.00
MOUNTING HOLE LOCATIONS
M19527
1/4-20 NUT (4 PLACES)
NOTE: MOUNTING SCREWS CA
10/01
N NOT PROTRUDE MORE THAN
0.5 INCHES INSIDE THE MACHINE.
11.84
3.50
CAUTION
CAUTION