Lincoln Electric IM916 POWER FEED 10M Dual WIRE FEEDER - Manual (Page 33)

B-15 OPERATION B-15
POWER FEED ® 10M DUAL WIRE FEEDER
M emory #4
Memory #5
Memory #6
Memory #1
-Weld Parameters
-Mode
-Preflow/Postflow
-Run in
-St art Par ameters
-Arc Control
-Cra ter Parameters
Memory #2
Memory #3
Procedure B
-Weld Parameters
-Mode
-Preflow/Post flo w
-Run in
-Start Parameters
-Arc Control
-Crater Parameters
-Burnb ack
Proce dure A
-Weld Parameters
-Mode
-Preflow/Post flow
-Run in
-Start Parameters
-Arc Control
-Crater Parameters
-Burnb ack
Procedure B
-Weld Parameters
-Mode
-Preflow/Pos tfl ow
-Run in
-Start Parameters
-Arc Control
-Crater Parameters
-Burnback
Procedure A
-Weld Parameters
-Mode
-Preflow/Pos tflo w
-Run in
-Start Parameters
-Arc Control
-Crater Parameters
-Burnback
Head / Procedure Select
• Press to select head or change active
procedure.
• Changes to weld settings affect
active procedure only.
O l
d b ti t
Memory
• Permanent storage for procedure
settings.
• Six available memory locations. One
procedure (A or B) can be stored in
each.
FIGURE B.4
HEAD 1
PROCEDURE
HEAD 2
PROCEDURE
A GUN GUN B A
B
M M
PRESS AND HOLD TO SAVE
MEMORY