Lincoln Electric IM635 RED-D-ARC GX 271Chopper LPG - Manual (Page 29)

GX 271 Chopper LPG
C-3 C-3 ACCESSORIES - CONNECTION DIAGRAMS
6 PIN
AMPHENOL
TO WORK
14 PIN
AMPHENOL
LN-25
N.E. PLACE THE WELDING TERMINALS SWITCH IN THE "ALWAYS ON" POSITION.
N.C. PLACE THE MODE SWITCH IN THE "WIRE WELDING-CV" POSITION.
N.F. PLACE IDLER SWITCH IN "AUTO" OR "HIGH" IDLE POSITION AS DESIRED.
S24095-1
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE
AND FUTURE APPLICATIONS. SEE OPERATING MANUAL.
ELECTRODE CABLE
WIRE FEEDER
TO WORK
WORK CLIP LEAD
OPTIONAL K857
REMOTE CONTROL
GX-271 / LN-25 ACROSS THE ARC CONNECTION DIAGRAM
WARNING
or service this equipment.
Keep away from moving parts.
WITH OPTIONAL K857 REMOTE CONTROL
Only qualified personnel should install,use
N.B. CONNECT WELDING CABLES TO OUTPUT STUDS FOR DESIRED POLARITY. POSITION THE WIRE FEEDER
VOLTMETER SWITCH TO MATCH THE POLARITY OF THE ELECTRODE CABLE.
N.D. IF REMOTE OUTPUT CONTROL IS USED, PLACE LOCAL REMOTE SWITCH IN "REMOTE" POSITION.
Do not operate with panels open.
before servicing.
Disconnect NEGATIVE (-) BATTERY LEAD
Do not touch electrically live parts.
Keep guards in place.
ELECTRODE TO WORK
A
GX-271 / LN-25 ACROSS THE ARC CONNECTION DIAGRAM
S24095-2
A
N.D. IF REMOTE OUTPUT CONTROL IS USED, PLACE LOCAL REMOTE SWITCH IN "REMOTE" POSITION.
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE
AND FUTURE APPLICATIONS. SEE OPERATING MANUAL.
N.B. CONNECT WELDING CABLES TO OUTPUT STUDS FOR DESIRED POLARITY. POSITION THE WIRE FEEDER
VOLTMETER SWITCH TO MATCH THE POLARITY OF THE ELECTRODE CABLE.
ELECTRODE CABLE
WIRE FEEDER
OPTIONAL K444-1
REMOTE CONTROL
TO WORK
WORK CLIP LEAD
Keep guards in place.
or service this equipment.
Keep away from moving parts.
Only qualified personnel should install,use
WARNING
WITH OPTIONAL K444-1 REMOTE CONTROL
6 PIN
AMPHENOL
14 PIN
AMPHENOL
TO WORK
LN-25
Do not operate with panels open.
Disconnect NEGATIVE (-) BATTERY LEAD
before servicing.
Do not touch electrically live parts.
ELECTRODE TO WORK
N.E. PLACE THE WELDING TERMINALS SWITCH IN THE "ALWAYS ON" POSITION.
N.F. PLACE IDLER SWITCH IN "AUTO" OR "HIGH" IDLE POSITION AS DESIRED.
N.C. PLACE THE MODE SWITCH IN THE "WIRE WELDING-CV" POSITION.