Lincoln Electric IM600 CYLINDER UNDERCARRIAGE KIT K1570-1 - Manual (Page 3)

3
STEP 3. INSTALL THE CABLE RETAINERS.
a. Locate the existing 1/4-20 screws located half
way up at the back of each case side.
b. Remove these screws with the 3/8 nut-driver
and mount the 2 cable retainers to each case
side as shown.
NOTE: The cable retainer
should be oriented as shown when mount-
ing. It should wrap around the case back
corner and lay flat.
STEP 4. INSTALL THE CASTER ASSEMBLY
FALLING EQUIPMENT can
cause injury.
• Lift only with equipment of ade-
quate lifting capacity.
• Be sure the machine is stable
when lifting it.
------------------------------------------------------------------
a. Attach the hoist lifting hook to the lift bail of the
machine. Lift the machine to allow enough
clearance to slide the caster assembly into
place.
b. Position the caster assembly at the front of the
machine between the machine base chan-
nels.
c. Mount with four 3/8-16x1.00 threading cutting
screws provided with the kit, using two on
each side of the base.
WARNING