Lincoln Electric IM600 CYLINDER UNDERCARRIAGE KIT K1570-1 - Manual (Page 2)

2
INSTALLATION OF THE K1570-1 DUAL
CYLINDER UNDERCARRIAGE KIT
STEP 1. INSTALL THE HANDLE.
a. With the 3/8" nut driver or wrench, remove the
four existing screws from the case sides. Save
the screws to install the handle.
b. Install the handle using the four screws saved
from the previous step.
STEP 2. INSTALL THE UPPER CYLINDER SUP-
PORT BRACKET.
a. Remove the two existing screws from the case
top and one screw from each case side. Save
the four screws.
b. Position the bracket as shown so that the two
holes in the bracket line up with the two exist-
ing holes in the machine case top.
c. With the 3/8" nut driver or wrench, install the
bracket at the top using the two previously
removed screws. Secure the bracket at the
sides with the two remaining screws.
Note
that one of the slots is slightly smaller than the
diameter of the screw to insure proper electri-
cal grounding.
p y p pp p y y y b v y
v y p y y v
WARNING CYLINDER m a y e x p l o d e i f d a m a g e d