Kushlan Products KPRC160 User Manual

Page 8

After 200 hours of operation, remove the upper belt cover to

check the V-belt tension (Figure 2).Tension

is proper if the

belt bends about 10mm when depressed strongly with finger

between shafts. Loose or

worn V-belts reduce power

transmission efficiency, cause weak compaction and reduces

the life of the

belt itself.

CAUTION:

Whenever the compactor's vibration becomes

weak or lost during normal operation regardless of

operation hours, check the V-belt and clutch

immediately.

Replacing the V-belt

Remove the upper and lower belt covers, Engage an offset

wrench (13mm) or the like to vibrator pulley

(Lower)fastening

bolt. Engage waste cloth or the like at midway of V-belt on the

left side and while

pulling it back strongly, rotate the offset

wrench clockwise so that the V-belt will come off.

Reinstalling the V-belt

Engage V-belt to the lower vibrator pulley and push the V-belt

to the left side of upper clutch and, in the

same manner as in

removal, rotate offset wrench clockwise so that the V-belt

goes back on.

Checking Clutch

Check the clutch simultaneously with V-belt checking. With

belt removed, check outer drum of the clutch

for seizure and

"V' groove for wear or damage with your eyes. Clean the "V"

groove as necessary. Wear

of lining or shoe should be

checked with running check. If the shoe is worn, power transmission becomes

deficient and slipping will result.

KPRC160 PLATE COMPACTOR

Model

KPRC160H

KPRC160R

KPRC160L

KPRC160K

Engine

Air-cooled,single cylinder,4-stroke

Engine Type

Petrol,Honda

GX160

Petrol,Robin

EY20

Petrol,Loncin

G270F

Diesel,

Kipor170F

Power (hp)

5.5(4.0kw)

5.7(4.2kw)

5.0(4.0kw)

3.8(2.8kw)

Weight (kg)

125(275 lbs)

130(286 lbs)

Centrifugal force (KN)