Kushlan Products KPRC160 - Manual (Page 7)

Remove soil and clean the bottom of compaction plate.
Check for loose screws including tightness. See Table 3 below ( Tightening torque), for retightening.
TABLE 3
TIGHTENING TORQUE (in.kg/cm) Diameter
Material 6mm 8mm 10mm 12mm 14mm 16mm
4T 70 150 300 500 750 1100
6-8T 100 250 500 800 1300 2000
11T 150 400 800 1200 2000 2900
Changing Vibrator Oil
When changing the vibrator oil, remove the drain plug located at the bottom-right of the vibrator, and
simply tip the compactor to drain the oil. Note that the oil will drain more easily while it is hot. Replace the
oil with 200ML of 10W-30 motor oil.
Air Filter
1. The air filter element should be cheaned because a clogged air cleaner can cause poor engine
starting, lack of power and shorten engine life substantially.
2. To clean or replace air filter loosen the wing nut on the air filter housing (Figure 1), remove the cover
and take out air filter cartridge. If only cheaning of the air filter is desired blow through the air filter
cartridge from the inside, moving a jet of dry compressed air up and down until all dust is removed.
CAUTION:
NEVER attempt to check the V-belt with the engine running. Severe injury can occur if your
hand gets caught between the V-belt and the clutch. Always use safety gloves.
Checking and Replacing the V-belt and Clutch