Alliance Laundry Systems H236I - Manual (Page 18)

16 685945
Step 4:
Set WASH/RINSE Temperatures
Set at HOT (COLD rinse), WARM (COLD rinse) or
COLD (COLD rinse).
NOTE: Always follow Manufacturer’s care labels.
Step 5:
Select Fabric Selector
Set regular loads at NORMAL or PERM PRESS. Set
delicate loads at DELICATE.
Step 6:
Insert Money
Place coin(s) in slide and carefully push in as far as
possible and then pull slide out as far as possible. After
IN USE
light comes on (indicating start of cycle), press
the PUSH-TO-START button.
Indicator Lights
IN USE Light:
This light will remain on while washer is in use.
DOOR LOCKED Light:
This light will come on after the start button has been
pushed and the washer door has locked. It will remain on
until the wash cycle has ended.
FINAL SPIN AND TUMBLE Light:
This light will come on at the start of the final spin and
remain on until the wash cycle has ended.
CLOSE DOOR Light:
This light will come on if door is not closed tightly.
Firmly push door until light goes out.
IMPORTANT: If washer fails to operate properly
after installation, make sure electrical service and
water supply faucets are turned on. Are all the
controls properly set? Have a qualified service person
refer to the wiring diagram (located inside of washer
cabinet), check for broken, loose or incorrect wiring.
The washer will stop (pause) shortly before the first spin
and final spin.
HOT COLD
WARM
WASH TEMPERATURE
CPW158A
PERM PRESS
NORMAL DELICATE
FABRIC SELECTOR
CPW158B
D363I
To reduce the risk of bodily injury, do not
remove laundry from washer until all lights
are out, and all moving parts have stopped.
W092
WARNING