HATZ Diesel 1D90 - Manual (Page 9)

3.2. Transport
A lug is provided on top of the engine
as standard equipment, so that the en-
gine can be lifted safely. It is not suitable for
lifting complete machines or similar with the
engine attached, and this is strictly prohibited.
(See Chapter 2.)
3.3. Instructions for installation
The „Manual for Selection and Installation of En-
gines“ contains all the information you need if
your engine has not yet been installed on or in
the equipment it is intended to drive, or set up
in its correct operating position. You can obtain
a copy of this manual from your nearest HATZ
service station.
Moreover, we would like to point out that in this
case, commissioning is prohibited until it has
been verified that the machine into which this
engine is to be incorporated complies with the
regulations of the EC Machinery Directive.
Refer also to Chapter 9 „Declaration for Incorpo-
ration“.
3
The permitted loads and elements on
the speed adjusting lever and the stop
lever should be observed as an exess can lead
to damage to the contacts and inner governor
parts.
3.4. Load on engine
Operating the engine for a lengthy period off-
load or at very low loads can affect its running
quality.
We therefore recommend a minimum engine
load of 15 %. If operated at such low loads, it is
best to operate the engine at a significantly high-
er load for a short period before switching it off.
3.5. Type plate
4
The type plate is placed on the crankcase resp.
on the capsule (chapt. 2) and includes the fol-
lowing engine information:
➀ engine type
➁ code (only for special equipment)
➂ engine number
➃ max. engine speed
For any offer as well as spare parts orders it is
necessary to mention these data (also see spare
parts list, page 1).
➀ ➁
➂
➃
70°
F 120 N
M 12.6 Nm
–
–
F 10 N
M 0.35 Nm
–
–
<
<
<
<
START
STOP
+
8