beautypg.com

HATZ Diesel 1D90 User Manual

Page 24

background image

5.3.

Maintenance every

250

hours of operation

5.3.1. Oil bath air cleaner maintenance

34

Catch waste oil and dispase acc. to
environmental regulations.

– Take off the oil reservoir „1“ and clean it.

– Remove contaminated oil and sludge from the

oil tank, and clean it out.

– Take off rain cap „2“ and clean it.

– Clean the entire length of intake pipe „3“.

– Check the inserted seal and renew if in poor

condition.

– Fill the oil reservoir up to the mark with engine

oil and re-assemble the oilbath air cleaner,
Chap. 4.1.2.

– If the filter pack is very dirty, also clean the

upper part of the air cleaner as follows:
Remove the upper part of the air cleaner from
the engine and rinse it in diesel oil.

– Before re-assembling the air cleaner, allow the

diesel fuel to drip off thoroughly, or wipe it off.

– Never attempt any repairs (welding, brazing

etc.) to the oilbath air cleaner, or it may be
rendered useless and the engine may also be
damaged.

– If the sealing face is uneven, the air cleaner

body cracked and/or the filter wool content is
incomplete, install a new air cleaner.

– Attach the upper part of the air cleaner with a

new flange gasket.

35

– Sealing package acc. picture 35 is mounted at

engines 1D41, 1D42 and 1D50.

36

– Shim washers „1“ should be installed with the

convex side (outward curve) towards the nut.

– Re-assemble the complete air cleaner and fill it

with oil to make it ready for further operation.

1

2395 / 13

23

This manual is related to the following products: