Elitegroup L373N1 v.6 - Manual (Page 17)

¦ chapter 4 trouble shooting
4-17
Firewire (IEEE1394), USB2.0, and S/PDIF
Problems
The USB device does not work -
?? Windows NT 4.0 does not support USB protocols
?? Check the settings in the Windows Control Panel.
?? Make sure you have installed the necessary device
drivers.
?? Contact the device vendor for additional support.
The IEEE1394 port does not work -
?? Go to [Start > Control Panel > System > Hardware >
Device Manager]. You should see an entry which reads “IEEE
1394 Bus host controllers”. If it does not exist, Windows has not
detected the host controller or the device driver has not been
installed properly. If there is a yellow mark or red-cross on the
1394 host controller, it may be a device or resource conflict.
Replace or update the device driver from the factory CD-ROM
disk or consult Windows manual on how to solve the resource
conflict problem.
?? Make sure the cable is fully connected.
?? Make sure you have installed the necessary device
drivers.
?? Contact the device vendor for additional support.
The SPDIF port does not work -
?? Make sure the cable is fully connected.
?? You need to enable the S/PDIF output in the audio volume
control panel. Go to Chapter One How to Enable S/PDIF Digital
Output section for details.
?? Make sure the AC3 or DTS audio decoder is working
properly.