Elitegroup L373N1 v.6 - Manual (Page 13)

¦ chapter 4 trouble shooting
4-13
Network Adapter / Ethernet Problems
The Ethernet adapter does not work -
?? Go to [Start > Control Panel > System > Hardware >
Device Manager]. Double-click on Network Adapters and check
if SiS 900 PCI Fast Ethernet Adapter appears as one of the
adapters. If it does not exist, Windows has not detected the SiS
Ethernet adapter or the device driver has not been installed
properly. If there is a yellow mark or red-cross on the SiS
network adapter, it may be a device or resource conflict.
Replace or update the device driver from the factory CD-ROM
disk or consult Windows manual on how to solve the resource
conflict problem.
?? Make sure the physical connections on both ends of the
cable are good.
?? The hub or concentrator may not be working properly.
Check to see if other workstations connected to the same hub or
concentrator are working.
The Ethernet adapter does not appear to operate in the
100Mbps transmission mode -
?? Make sure the hub you are using supports 100Mbps
operation.
?? Make sure that your RJ-45 cable meets the 100Base-TX
requirements.
?? Make sure the Ethernet cable is connected to the hub ?
socket that supports 100Base-TX mode. The hub may have
both 100Base-TX and 100Base-T sockets.