Elitegroup G400 - Manual (Page 4)

ii
Notices
Federal Communications Commission Radio Frequency
Interference Statement
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and if not installed and used in accordance with the instruction
manual may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
^ Reorient or relocate the receiving antenna
^ Increase the separation between the equipment and receiver
^ Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
^ Consult the dealer or an experienced radio TV technician for
help
Notice:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment. Shielded interface cables and a non-
shielded AC power cord must be used in order to comply with
emission limits.
This equipment is to be used with power supply:
Input: 100-240V AC, 50-60Hz, 1.5A, Universal
Output: 19V DC, 3.42A, 65W
There is no internal power supply.