Elitegroup A907 (VD) - Manual (Page 47)

35
Loading a Disc
To play a CD disk, follow the instructions listed below.
1. Push the CD-ROM eject button on the CD drive door. Gently pull the tray all the way out.
2. Carefully lift the CD disk by the edges and make sure the shiny surface is face down (the
side with no writing on it). Carefully insert the CD disk onto the tray. Push the CD disk
down gently so that it snaps onto the center ring.
3. Push the tray back into the drive.
To remove a CD disk, do the following:
1. Check the LED display and make sure that the computer is not accessing the CD- ROM drive.
2. Push the eject button and pull the tray all the way out.
3. Carefully pick up the CD by the edges and – while pressing down on the center ring –
remove the CD disk from the tray.
Do not insert any foreign objects into the disc tray. If you
experience difficulty when ejecting the CD disk tray, stretch a paper
clip (or use a pin or a thin metal rod) and insert it into the emergency
eject hole located on the right side of the front panel. The CD disk
tray should eject immediately. This procedure can also be used to
remove a CD from the drive when the DeskNote is powered off.