Enable ip icmpreply, Show ip icmpreply – Allied Telesis 86222-27 User Manual
Page 41
Patch 86222-27 For Rapier Switches
41
Patch 86222-27 for Software Release 2.2.2
C613-10319-00 REV Z
If ALL is specified, all configurable ICMP message replies are disabled. If
NETUNREACH is specified, all network unreachable message replies are
disabled (RFC792 Type 3 Code 0). If HOSTUNREACH is specified, all host
unreachable message replies are disabled (RFC792 Type 3 Code 1). If
REDIRECT is specified, all ICMP redirect message replies are disabled (RFC792
Type 5 Code 0, 1, 2, 3).
Example
To disable all configurable ICMP messages, use the command:
DISABLE IP ICMPREPLY=ALL
See Also
ENABLE IP ICMPREPLY
DISABLE IP ECHOREPLY
SHOW IP ICMPREPLY
ENABLE IP ICMPREPLY
Syntax
ENABLE IP
ICMPREPLY[={ALL|NETUNREACH|HOSTUNREACH|REDIRECT}]
Description
This command enables ICMP reply messages.
If ALL is specified, all configurable ICMP message replies are enabled. If
NETUNREACH is specified, all network unreachable message replies are
enabled (RFC792 Type 3 Code 0). If HOSTUNREACH is specified, all host
unreachable message replies are enabled (RFC792 Type 3 Code 1). If
REDIRECT is specified, all ICMP redirect message replies are enabled (RFC792
Type 5 Code 0, 1, 2, 3).
Example
To enable all configurable ICMP messages, use the command:
ENABLE IP ICMPREPLY=ALL
See Also
ENABLE IP ECHOREPLY
DISABLE IP ICMPREPLY
SHOW IP ICMPREPLY
SHOW IP ICMPREPLY
Syntax
SHOW IP ICMPREPLY
Description
This command display the status of configurable ICMP messages (Figure
Figure 1: Example output from the SHOW IP ICMPREPLY command:
SHOW IP ICMP REPLY MESSAGES
--------------------------------------------------------------------------------
ICMP REPLY MESSAGES:
Network Unreachable ................ disabled
Host Unreachable ................... disabled
Redirect ........................... enabled
--------------------------------------------------------------------------------