Allied Telesis 86222-27 - Manual (Page 14)

14 Patch Release Note
Patch 86222-27 for Software Release 2.2.2
C613-10319-00 REV Z
The EPORT parameter in the SHOW SWITCH L3FILTER ENTRY command
was displaying incorrectly after an issue was resolved in PCR02374. The
command now displays correctly.
DHCP entry reclaim checks are now delayed by 10 seconds if the entry is
unroutable because the interface is not up.
Support for multi-homed interfaces has been added.
Under some circumstances a fatal error occurred if a large amount of data
was pasted onto the command line. This issue has been resolved.
When the switch was under heavy learning load, some MAC address were
lost. This issue has been resolved.
In the ADD IP ROUTE FILTER command, when the optional parameter
INTERFACE was included, the filter was not applied to the flooding of
OSPF external LSAs. Also, in the command SHOW IP ROUTE FILTER, the
output of the interface name was truncated when the name was more than
six characters long. These issues have been resolved.
The source net mask has been removed from DVMRP prune, graft and
graft-ack messages.
Under some circumstances, multiple default routes were created for
DVMRP. This issue has been resolved.
The source mask is now always 0xffffffff in the DVMRP forwarding table.
The temporary route in the DVMRP route table was not displaying
correctly. This issue has been resolved.
An IGMP entry was erroneously added for the reserved IP address. This
issue has been resolved.
PCR 02408 Module: SWI Network affecting: No
PCR: 02427 Module: DHCP Network affecting: No
PCR: 02463 Module: DVMRP, IPG Network affecting: No
PCR 02465 Module: TTY Network affecting: No
PCR: 02489 Module: SWI Network affecting: No
PCR 02506 Module: OSPF, IPG Network affecting: No
PCR: 02509 Module: DVMRP Network affecting: No
PCR 02526 Module: DVMRP Network affecting: No
PCR 02538 Module: DVMRP Network affecting: No