Elitegroup 532 User Manual
Page 10
6.
7.
8.
9.
10.
11.
12.
13.
b.
c.
d.
e.
f.
14.
15.
16.
17.
Lay this equipment on a reliable surface when installed. A drop or fall could cause injury.
Make sure to use the right voltage for the power source when connecting the equipment to the power
outlet.
Place the power cord in such a way that people can not step on it. Do not place anything on top of the
power cord.
All cautions and warnings on the equipment should be noted.
If the equipment is not use for a long time, disconnect the equipment from the main power outlet to
avoid being damaged by transient overvoltage.
Never pour any liquid into the opening, this could cause fire or electrical shock.
Never open the equipment. For safety reason, the equipment should only be opened by a qualified
service personnel.
If on the following situations arises, get the equipment checked by a service personnel:
a.
The Power cord or plug is damaged.
Liquid has penetrated into the equipment.
The equipment has been exposed to moisture.
The equipment has not worked well or you cannot get it work according to the user's manual.
The equipment has dropped and damaged.
If the equipment has obvious sign of breakage.
Do not leave this equipment in an environment unconditioned, storage temperature above 60
°C (140°f),
it may damage the equipment.
The unit can be operated at an ambient temperature of max. 35
°C.
The sound pressure level at the operators position according to IEC 704-1: 1982 is equal or less than
70 dB(A).
Power Cord Requirements
The power cord set used with the AC adaptor must meet the requirements of the country where you use
the AC adaptor, whether it is 100-120 or 200-240 Vac. The following information explains the
requirements for power cord set selection.
2