Elitegroup AG200 Series VGA Card - Manual (Page 13)

Chapter 2: Hardware Installation
DVI to CRT Adapter
(optional)
SCON: 7-pin AV/S-Video Connector
S to AV transfer
cable (optional)
♦ VGA Connector—CRT
AG200 Series provides a standard VGA connector that
allows you to connect a CRT monitor. Simply plug your
monitor cable into the VGA connector on your card, and make
sure that the other end of the cable is properly connected to
your monitor.
Installing the Card
To install AG200 Series card to your computer, please
follow the steps below:
1. Unplug the computer and remove the cover.
2. Insert the graphics accelerator card.
2-1. Locate the AGP slot on your mainboard.
2-2. Grasp the AG200 Series accelerator card by edges.
2-3. Align it with the empty AGP slot on the mainboard
and gently insert it into place. Make sure the card
evenly and completely seated in the slot.
3. Reconnect all cables and replace the cover.
Note: AG200SP-64-- You have to install in the PCI slot.
11