Nilfisk-ALTO BSG81 User Manual

Page 10

Place a new MEGAfilt

Super TEX dust bag into the hol-

der and close the dust compartment cover.

Important
A MEGAfilt

Super TEX dust bag or textile filter

must be properly in place or the dust compart
ment cover will not close. Do not force the cover
if it does not close easily. Inspect the bag
installation and adjust it as needed.

Changing the dust bag

Replacing the

MEGAfilt

SuperTEX dust bag

Ⅲ If the dust bag change indicator lights up brightly

and constantly while the nozzle is not on the carpet
and the highest suction setting is being used, you
must:

a) check whether the nozzle, the suction pipe or the

hose are blocked.

b) sometimes the type of waste in the bag nessitates

the change even if the bag is not full.

Ⅲ Operate the dust compartment handle in the

direction of the arrow to open the dust
compartment cover.

Seal the MEGAfilt

SuperTEX dust bag by pulling the

sealing strip and pull up to remove the bag.

Using MEGAfilt

SuperTEX dust bags

If necessary, a MEGAfilt

SuperTEX dust bag can be

used instead of the dust container.

Ⅲ Open the dust bag compartment cover

Ⅲ Remove the dust container and fit the

MEGAfilt

SuperTEX dust bag.

Ⅲ Close the dust bag compartment cover.

You have bought an extremely powerful device. The highest suction setting is therefore
only recommended for heavily soiled, short-pile carpets and hard floors.

The desired level of suction can be adjusted to any level using the suction regulator
switch.
Ⅲ Low suction range:

For vacuuming delicate fabrics, e.g. curtains.

Ⅲ Middle suction range:

For daily vacuuming of lightly soiled floors.

Ⅲ High suction range:

For vacuuming durable floor coverings, hard floors and for heavily soiled surfaces.