Davey MaxiFlow SPA POOL PUMP - Manual (Page 6)

6
Starting the Pump
To operate efficiently and prevent pump damage there must be a free flow of water
to and from the pump. Before starting ensure that:
- all pipework is correctly sealed.
- the pool/spa water level is at the correct height.
- that all appropriate valves are open and there is nothing preventing the flow of
water through the system.
1. First prime the pump by ensuring that the pump is below the water level of the
spa pool.
2. Connect to the power supply or spa controller as applicable and switch on.
3. Allow the pump to run, so that any air trapped may be expelled.
4. If prime is not established within less than a minute, as evidenced by a strong
flow of water, switch off the pump and repeat the procedure.
Pump Operation
The water level of the spa or spa pool should always be maintained to at least the
spa jets, thus ensuring water is in the pump at all times.
Never run pump dry. Running the pump with no water may damage the
mechanical seals, causing leakage and flooding. Dry running damage and
associated damage is not covered under warranty.
Failure to undertake regular maintenance may cause damage not covered
by warranty.