Davey PowerMaster ECO-SERIES - Manual (Page 11)

11
To operate an automatic pool cleaner with your PowerMaster ® Eco
Series pump:
1. Activate the High Flow setting and allow the pump to fully prime by
running for around 2 minutes. You will know the pump is primed when
you can see a strong flow of water through the clear leaf basket lid.
2. When all air is expelled from the leaf basket, connect the pool cleaner
hose firmly into the skimmer plate or dedicated wall suction.
3. Select the speed setting that enables best performance from your
automatic pool cleaner. Mid setting should be ample for most cleaners
but if the cleaner requires better performance, activate the High Flow
setting. Eco Flow should be suitable to run a Davey Frill-Neck WIZARD
pool cleaner.
4. The cleaner should only be connected for as long as is required to clean
the surface of your pool. When cleaning is complete, disconnect the
cleaner and remove the skimmer plate from the skimmer box.
NOTE: To get optimum energy efficiency from your PowerMaster ® pump
DO NOT keep the automatic pool cleaner connected when cleaning is
not required.
5. Reactivate the most efficient speed setting for daily filtration. The ECO
Flow setting is recommended.
Maintenance:
Emptying the Strainer Basket
The strainer basket should be inspected frequently through the transparent
lid and emptied when a build up of rubbish is evident. The directions below
should be followed.
1. Switch off pump.
2. Unscrew the strainer basket lid anti-clockwise and remove.
3. Remove the strainer basket by lifting upwards from its housing.
4. Empty the trapped refuse from the basket. Hose out with water if necessary.
NEVER knock the plastic basket on a hard surface as it will cause damage.
5. Check the strainer basket for cracks, replace the strainer basket in the pump if OK.
6. Replace the lid and ensure that it seals on the large rubber o’ring. Firm
hand tightness only is required. The o’ring & thread can be lubricated
with Hydra slip or equivalent products.