Ariens 927046-056 - Manual (Page 14)

4 - 14
4.5 MOWER BELT ADJUSTMENT
Adjust mower belt after first five (5) hours of operation.
To adjust 28" and 30" mowers (Figure 5):
1. Place height control lever in midnotch position,
depress spring clip and tighten yoke on front of unit
with a 3/4" socket wrench.
2. When tightening cap screw, hold mower clutch
lever so that front edge of lever is positioned in line
with rear edge of forward notch of quadrant.
3. Tighten belt just enough to prevent slippage under
load. Mower clutch lever (when tightening cap
screw) will move slightly to rear of this point when
tension is correct.
To adjust the 32" mower:
1. The 32" mower belt clutch rod should be adjusted
so the compressed spring length is from 5-1/4" to
5-3/8" (13.3 to 13.6 cm) when belt is engaged
(Figure 6).
2. Belt engagement should occur when front edge of
mower clutch is positioned in line with rear edge of
forward notch of quadrant (as viewed through slot
in left side of cowl).
3. Full locked-in engagement should occur when
lever is positioned completely into front notch of
quadrant. (Some resistance should be felt when
moving lever into notch).
4.6 CLUTCH AND BRAKE
Clutch and brake adjustments are dependent upon
each other. If depressing clutch and brake pedal fully
does not stop riding mower and/or hold it on hill, brake
must be adjusted.
1. With speed selector in neutral (N), depress clutch
pedal fully and engage parking brake.
2. Adjust double nuts on clutch rod until carrier yoke
clears neutral stop by 1/8" to 1/4" (3.18 to 6.4 mm).
Figure 4
Figure 5
1. Steering Gear
2. Adjustment Cap Screw
3. Height Control
4. Height Lever 5. View Quadrant Through
Slot
6. Spring Clip
1
2
3
4
5
6
Figure 6
1. Mower Pulley
2. Mower Belt
3. Fixed Idler 4. Clutching Idler
5. Belt Finger
6. Adjustable Clutch Rod
1
2
3
4
5
6