Burcam 300521 HOT WATER RETENTION PUMPING SYSTEM (GENIE) - Manual (Page 4)

STEP 15
STEP 13
STEP 16
STEP 14
STEP 17
STEP 18
4
Screw the bypass valve at an appropriate place, with the hot water side on left and the vertical
port facing to the faucet.
From these vertical ports, connect the 1/2’’ to 3/8’’ flexible hoses to the faucet, respectively for
the hot and cold sides.
Then, connect the 1/2’’ to 1/2’’ flexible hoses from water supplies to the side ports of the
bypass valve, respectively for the hot and cold sides
Open the sink supply valves and close the hot water faucets previously opened to drain the
hot water pipe.
Open the water supply to the water heater. Then open the ball valves before and after the
pump.
Open both the hot and cold water faucets above the bypass valve and wait till all the air has
been evacuated from the piping.
When the air is completely purge, the electric power supply can now be re-activate to the
water heater.
(Timer set-up)
The plastic cover can be remove by turning it counter clockwise.Turn the hour hand clockwise
to set it with the actual hour time.
When the little red knob is at the ‘O’ position, the pump is set off. When this red knob is slided
to the ‘I’ position, the pump is set operational. To use the timer to turn the pump on and off,
align the red knob to the line in the middle of the ‘O’ and ‘I’ position. You can now make your
selection between these 3 choices.
Use the timer to turn the pump on and off while required. For example, the system
can be on from 5:30am to 9:00am and from 4:30pm to 11:30pm. Each little sliding
switch around the timer is representing 15 minutes. To set this example, push
the slides out accordingly to the hour scale around the timer, as shown on the picture C.
Install the electric cord of the pump in a 3 prong electrical outlet. Make sure the electrical cord
is tied, so it doesn’t touch any hot water pipes that may damage same.
STEP 8
STEP 9
STEP 10
STEP 11
STEP 12
Picture C
FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029