beautypg.com

Front panel controls – Boltek LD-250 User Manual

Page 21

background image

O P E R A T I O N

18

Front Panel Controls


Main Power Button
The main power button disconnects 12V power from the LD-250, the antenna,

and the GPS connector on the rear of the LD-250.

Main Power Indicator
The power indicator illuminates to indicate 12V power is present at the LD-250. If

the indicator does not light when the unit is turned on check your 12V power

source.


Strike Indicator

The Strike Indicator emits a short flash when a lightning strike is detected. If the

Strike Tone Button is pressed the detector also emits a short beep.


Noise Indicator

The Strike Indicator emits a short flash when a noise signal is detected. If the

Strike Tone Button is pressed and Noise Beeps have been turned on in software

the detector will also emits a short beep.

Strike/Noise Switch

When pushed in, the internal beeper will emit a short beep when a strike or noise

signal is detected. When pushed out, no sound will emit from the internal beeper.

Close/Severe Alarm Switch

When pushed in, the internal beeper will emit a long beep when a close strike or

severe strike rate alarm is triggered. When pushed out, no sound will emit from
the internal beeper.

Close Indicator

The Close Indicator emits a long flash when a strike is detected within the set
close strike range. If the Close/Severe Tone Button is pressed the detector will

also emit a long beep.

Severe Indicator
The Severe Indicator emits a long flash when the strikes per minute rate reaches

or exceeds the set strike rate. If the Close/Severe Tone Button is pressed the

detector will also emit a long beep.