Boltek LD-250 - Manual (Page 17)

I N S T A L L A T I O N
14
USB Adapter Cable
If your computer has an available com port (a male 9 pin DB connector on the rear of the
computer) you should use the RS232 cable to connect your LD-250 directly to your
computer.
If your computer does not have a com (RS232) port available you should use the USB
adapter cable to create an additional com port for your computer. Once the cable and
driver are installed on your computer an extra com port will show up on your System
Device Manager.
Installing the USB Adapter Cable:
With your computer turned on plug the USB adapter cable into a spare USB port on your
computer or hub. USB devices may be plugged and unplugged with the power on.
Windows will detect the new device and prompt you to install a driver:
Place the USB Drivers CDROM in your computer disk drive and click on Next. Windows
will then display a list of drivers found on the disk: