ReadyLIFT GMC Envoy SST Lift Kit, 2002-2009, 2WD & 4WD - 2.0F/1.0"R" - Manual (Page 6)

ReadyLift
®
(Part# 69-3065)
2002-2008 Chevy Trailblazer/GMC Envoy
Installation Instructions
Revised
12-30-08
ReadyLift Suspension, Inc.
3201 W. MacArthur Blvd, Santa Ana, CA, 92704
T o l l F r e e ( 8 8 8 ) 9 2 2 - 2 2 9 4 Fa x 7 1 4 -8 6 2 -2 9 7 2
Please read instructions thoroughly and completely before beginning installation.
Check www.Readylift.com for any installation instruction updates
Installation by a trained mechanic is recommended.
The ReadyLift coil will mount on top of the coil. Lower jack enough to reinstall the factory coil with the Ready-
Lift spacer on top of it.
21. 22.
Raise the jack and reconnect the rear shock. Tighten to
55 ft-lb. Repeat steps 17-22 on opposite side. Install the
upper sway bay end links and tighten to 74 ft-lbs. Press
the ABS line clip back into the frame rail on both sides.
Install the factory wheels and tires and lower the vehicle
to the ground. Be sure to double check that all hardware
is to proper torque. Re-torque all hardware after 500
miles.
23.
Wheel and Tire Fitment
Due to the design of the front suspension, wheel
spacers may be needed clear larger tires on the OE
wheel. This may also apply to aftermarket wheel
and tire combinations. Also, because of the unique
6 on 5 bolt pattern, there are only a limited number
of aftermarket wheels available for this vehicle. You
can purchase wheel adapters from Fred Goeske at
www.wheeladapter.com and change the bolt pat-
tern to the more common 6 on 5.5 bolt pattern.