PrehKeyTec MCI TouchKey - Manual (Page 15)

The text written on the key. Special characters have to be written using character
references as follows: "&#character;" An example for creating a new line will be
"
". A list of the ASCI characters is found at the end of this document. Numbers
are to be written in decimal form.
Example: drinks
table 1
This describes the characteristics of the fonts used in labeling buttons.
The following table lists the HEX values for the font properties:
Bit 0 Center text horizontally
Bit 1 Center text vertically
Bit 2 Right justify text
Bit 3 Bottom justify text
Bit 4 Do not word wrap text
Bit 5 Add horizontal space for border
Bit 6 Add vertical space for border
Bit 7 Turn alignment on
Example: 0
Describes the properties of the frame around a button.
Value ranges from 0-255(dezimal).
The table below list the HEX values:
Bit 0 The rectangle is drawn with rounded corner
Bit 1 A shadow is drawn at the right and the bottom
Bit 2 Blank pixels are drawn outside the rectangle
Bit 3 The inner part of the rectangle will be erased
Bit 4 Erasing of the inner part is done with the inverse setting
Bit 7 Display no frame
Example: 128
PrehKeyTec GmbH MCI_TouchKey_TechDoc_RevC_en.doc - 2011-02-09 Page 15/40