PreSonus Temblor T10 - Manual (Page 7)

2 Hookup
2.1 Rear-Panel Connections and Controls
Monitor Station V2
Owner’s Manual
3
2 Hookup
2.1 Rear-Panel Connections and Controls
2.1.1 Inputs
Line-level Inputs: The Temblor T10 provides a choice of three input pairs: two sets
of balanced inputs (XLR and ¼” TRS) and one pair of RCA unbalanced inputs. When
both of the balanced connections are in use, the TRS inputs will take precedence
over the XLR inputs. The RCA inputs will sum into either balanced connection.
Power User Tip: Connect both the left and right inputs if you are using the onboard
crossover in your Temblor T10 to connect your full-range monitors or if you’re running
your Temblor T10 independently from a stereo source (such as the Monitor Station
or Central Station). This will ensure that your Temblor T10 receives the low-frequency
content from both channels. If your audio source provides a mono or LFE output, you only
need to connect one input—either L or R.
Input Gain: Sets the level of the input signal before it is amplified.
2.1.2 Outputs
Outputs: The Temblor T10 provides two pairs of balanced outputs: XLR and ¼”
TRS. The full-range signal connected to the stereo inputs on the T10 is passed
through to these outputs. Use these outputs to connect your main left and
right studio monitors. If the High Pass Filter switch is engaged, frequencies
below 80 Hz are not sent from these outputs.
Sub Out: This balanced XLR output sends the low-frequency signal from the lowpass
filter to a second Temblor T10. When connecting a second T10 to this output, set its
Low Pass Filter control to its highest setting.
Sleeve:
Ground
Ring:
[-]
Tip:
[+]
1 2
3 Ground
XLR TRS
[-]
[+]