PreSonus StudioLive 16.0.2 - Manual (Page 59)

55
StudioLive™ 16.0.2 Owner’s Manual
Ov
er
view
Con
trols
Hook
up
Resour
ces
Getting S
tar
ted
Digital E
ffec
ts
Mast
er C
on
trol
Tr
oubleshooting and W
arr
an
ty
Digital E
ff
ec
ts
Mast
er C
on
tr
ol
Navigate to Pages 4 and 5 of your StudioLive system menu
and set each page up as shown in these images:
Setting Up Different MIDI Channels on Your FCB1010
Next, you need to configure the pedals on your FCB 1010 to send information
on different MIDI channels. We will use Pedal 1 exclusively for Scene changes,
Pedals 2 and 3 for FXA recall, and Pedals 4 and 5 for FXB recall. You can customize
your pedal to meet your needs; these instructions merely provide a guideline.
1. Boot your FCB1010 into Global configuration mode by holding
the Down pedal while powering on the FCB1010.
2. PreSonus recommends that you do not use Direct Select mode. When your
FCB1010 boots up, you will see that the green LED above Direct Select is
illuminated. Make sure that the red LED on pedal 10 is not illuminated.
3. Press the Up pedal to select MIDI Function.
4. Press Pedal 1 so that its red LED is flashing.
5. Press the Up pedal again to select the MIDI channel for Pedal 1.
6. For our purposes, Scene recall is assigned to MIDI Channel
1. Press Pedal 1 so that the LED readout displays “1.”
7. Press the Up pedal twice to confirm the change
and cycle back to MIDI Function.
8. Next, you’ll assign the MIDI channel for FXA Recall.
Press Pedal 2 so that its red LED is flashing.
9. Press the Up pedal again to select the MIDI channel for Pedal 2.
10. This time, you will select MIDI Channel 2. Press Pedal
2 so that the LED readout displays “2.”
11. Press the Up pedal twice to confirm the change
and cycle back to MIDI Function.
12. Repeat steps 8-11 for Pedal 3.
13. Repeat steps 8-11 for Pedals 4 and 5, selecting MIDI Channel 3 for each.
You’re almost done! Now you need to set the global MIDI channel on which your
FCB1010 will control FXA and FXB output levels, assign/unassign FX to Mains,
and control the Main output level. Press Pedal 6 so that its red LED is flashing.
1. Press the Up pedal to select the MIDI channel for Pedal 6.
2. In our example, the global MIDI functions are set to MIDI Channel 4. But you
can assign global MIDI functions to the same channel as any of the recall
functions, if you prefer. Press Pedal 4 so that the LED readout displays “4.”
3. Press the Up pedal twice to confirm the change
and cycle back to MIDI Function
4. Repeat steps 1-3 for Pedals 7-9.
5. Press and hold the Down pedal to exit Global Configuration mode.
Making Presets on an FCB1010
In our example, we will create one preset for Scene recall, one for FXA assign/
unassign to Mains, and one for Main volume control. You can also use these
instructions to create presets for the remaining controllable parameters. We
will create a StudioLive bank of presets on Bank 00. If you have presets already
saved to this bank, you can use any of the other nine banks instead.