2 batch operations – Yokogawa 414 Batch Controller User Manual
Page 14
12 Operation
3.2 BATCH OPERATIONS
The Batch Control functions can be programmed, during Calibration, to operate in
one of two ways.
1. At the end of the batch, the STOP key must be pressed to reset the Batch
Total. (This must be done before another batch can be started.)
Batch
Quantity
Reached
Run
PAUSE
Stop Run
Run
Relay 1
Relay 2
Start Time
Prestop
Quantity
End of
Batch
End of
Batch
Stop
Count Down
Count Up