Wright Serial 54956 and higher - Manual (Page 9)

9
WARNING
WARNING
WARNING
operator safety. Ensure deck pitch is between 1/4 - 3/8”. (Refer to the maintenance interval chart at the end
of this manual)
1.9 Regular Mower Safety Maintenance
Keep your Wright mower in good operating condition, and keep safety devices and shields in place and in
working condition. Replace worn tire(s) with less than 3/32” of any tread groove left. Use tires with the tread
pattern specified by Wright Mfg., Inc. only. DO NOT change the engine governor settings or over-rev the
engine contrary to engine manufacturer specifications. Failure to comply can compromise operator safety,
shorten equipment life and void your manufacturer’s warranty. Keep all nuts, bolts, and screws tight to be
sure the equipment is in safe working condition. Check the blade mounting bolts for proper tightness every
eight (8) hours of operation. Check the blades for excessive wear and sharpness every four to eight (4-8)
hours of operation. Sharpen dull blades. Replace blades when they become excessively worn. The mower
should not be used after the blades or other part of the mower strikes a foreign object, until conducting a
thorough inspection and any damage is repaired. When inspecting or changing blades, turn off the blade
clutch switch, apply the parking brake, stop the engine and remove the key. Make sure the chute deflector is
always in place and operating properly. Replace if the deflector becomes worn or ceases to properly deflect
the grass in a safe manner. (Refer to the maintenance interval chart at the end of this manual)
1.10 Work Area Conditions & Inspection
Prior to operating the unit, carefully inspect all lawn/ground areas where you plan to use the mower for
hidden, hard-to-see objects or uneven ground that may be hidden in the grass. Clear the work area of
moveable objects such as wires, rocks, glass, toys, etc. that might be picked up by the mower and
dangerously thrown. Remove, if possible, or mark the location of all immovable objects or irregular areas
and be sure not to hit them with any part of the mower, its deck or the blades. Obstacles such as holes,
abrupt changes in ground contour, tree trunks, stumps or roots, pipes protruding from the ground, paving
edges, etc. in the path of operation can abruptly turn or stop the mower. This could throw you off the mower
or into and possibly over the handle bars causing serious injury or death. The faster you are moving the
more potential there is for injury. Mow only in daylight or in good artificial light. Keep away from drop-offs,
the edges of ponds, streams, pools, etc. especially at the bottom of slopes. Do not mow when children or
others are around. When the Wright mower is in use, never direct the grass discharge toward bystanders,
traffic, cars or buildings nor allow anyone within 50 feet of the machine while in operation. Thrown objects
can pass through glass windows and some walls of buildings. There is extreme risk of danger from thrown
objects or being cut by the blades of the mower or being run over if you lose control. Never operate the
mower in an enclosed area without good, approved ventilation. Exhaust fumes are dangerous.
1.11 Initial Operating Safety Guidelines
•
Read and understand the warnings on the instrument panel of the mower.
•
Keep a firm hold on the stationary handle at all times.
•
Keep both feet on the foot platform at all times.
•
Know the controls and how to stop quickly.
•
Before attempting to start the engine, follow all starting instructions below and in the engine operator’s
manual.
•
Look behind before backing up.
•
Before leaving the operator’s position, even momentarily, turn off the blade clutch engagement switch
and apply the parking brake. Keep others from coming near the mower. Get back on the mower as soon
as possible.
•
When leaving the Wright mower unattended, turn off the blade clutch engagement switch, apply the
parking brake, stop the engine and remove the key. Never leave the machine unattended on a slope in
case someone disengages the parking brake. This could create a rollover hazard.