Pfister GT49-CB0Y - Manual (Page 3)

E
N
G
L
IS
H
ENGLISH
ENGLISH
7
8
9
10
11
7 VALVE BODY ATTACHMENT
Remove Clip (7A) from Valve Body (7B) and save. From above sink, insert Valve Body
(7B) through Mounting Holes (7C). The HOT valve, labeled with Red Tag (7D), should
be positioned to the left side of the spout.
8 VALVE BODY INSTALLATION
Before proceeding, Valve Stems (8A) are to be set in the closed position. From
underneath sink, place Square Washer (8B) onto Valve Shank (8C) and tighten loosely
with Mounting Nut (8D). Temporarily place Handle (8E) onto Valve Stem (8A) to make
sure the handle levers are properly aligned to sink. Remove Handle (8E) and tighten
Mounting Nut (8D) until Valve Body (8F) is fi rmly secured to sink.
Do not use handles (8E) to tighten or to rotate Valve Bodies (8F)!
9 VALVE FLANGE ATTACHMENT
Place Plastic Ring (9A) and Flange (9B) over Valve Body (9C) covering the Valve Body
Washers (9D). Secure by threading the Plastic Nut (9E) onto the Valve Body (9C).
10 HANDLE INSTALLATION
Screw Stem Extender (10A) onto the Valve Stem (10B). With Valves in “Closed” position,
attach Handle Hubs (10C) onto Valve Stems (10B) and tighten Set Screws (10D) with the
Hex Wrench (10E) that is provided. Make sure Set Screw (10D) is securely tightened
to Handle (10C).
11 HOSE CONNECTION TO SPOUT BODY
From underneath sink, push the Center Connector (11A) onto receiving Tube (11B),
until unable to push any further. Pull down on the quick connect housing (11A). If the
housing and the Inner Collet (11C) separate slightly but do not pull off receiving Tube
(11B), the connection is secure.
3
7A
9A
7B
7B
7B
7D
8B
8B
9B
9E
9A
9B
9E
8D
8C
8C
8D
11B
11B
11B
11C
8E
7C
7C
8E
8A
8F
8F
9C
8A
9C
9D
9D
10A
10B
10C
10D
10E
11A
11A 11A
11A