En g li sh – Pfister VTP-E21W User Manual

Page 3

ENGLISH

8 WAX SEAL INSTALLATION

Carefully turn Toilet’s Base (8A) on it’s side on top of a Secure Padded Surface (8B).

Place Wax Seal (8C) firmly into the outlet of the toilet bowl.

10 TOILET BOWL INSTALLATION

A. Place Toilet’s Base (10A) onto Waste Outlet Hole (10B) with Tee Bolts (10C) passing

through Fixing Holes (10D).

B. Place the Plastic Washer (10E) and Metal Washer (10F) onto Tee Bolts (10C). Secure

by tightening the Mounting Nuts (10G) on to the Tee Bolts.

Do not over tighten!

Snap on Plastic Caps (10H) over bolts and nut as shown.

9 TANK INSTALLATION

The tank comes pre-installed with flushing mechanism. Attach Large Hose Nut (9A) to

Fill Valve Shank (9B) located on bottom of Tank (9C). Insert Rubber Gasket (9D) into

Water Inlet Hole (9E) on top of Bowl Shelf (9F). Place Tank (9C) on top of Bowl Shelf

(9F) and align Brass Bolts (9G) and insert Hose (9H) through corresponding Shelf

Holes (9J). From underneath bowl, screw Locking Nuts (9K) and Washers (9L) onto

Brass Bolts (9G) and tighten as shown.

Do not over tighten!

11 WATER SUPPLY CONNECTION

Connect Short Hose Nut (11A) onto Water Supply Valve (11B). Turn on Water Supply

Valve (11B) by turning Handle (11C) counterclockwise.

12 INTERNAL PLUMBING

Tank comes pre-installed with flushing mechanism.

11C

11A

11B

10F

10G

10C

10H

10E

10A

10B

10C

10D

OPEN