Pfister VTP-E10W - Manual (Page 4)

E
N
G
L
IS
H
ENGLISH
ENGLISH
10
14
15
11
16
10 TANK INSTALLATION
The tank comes pre-installed with fl ushing mechanism. Attach Large Hose Nut (10A)
to Fill Valve Shank (10B) located on bottom of Tank (10C). Insert Rubber Gasket (10D)
into Water Inlet Hole (10E) on top of Bowl Shelf (10F). Place Tank (10C) on top of Bowl
Shelf (10F) and align Brass Bolts (10G) and insert Hose (10H) through corresponding
Shelf Holes (10J). From underneath bowl, screw Locking Nuts (10K) and Washer (10L)
onto Brass Bolts (10G) and tighten.
Do not over tighten!
GO TO STEP 12
11 WATER SUPPLY CONNECTION
Use FTFE plumbers tape on threaded fi ttings according to manufacturer’s instructions.
Attach Large Hose Nut (11C) to Fill Valve Shank (11D) located on rear of Toilet Bowl.
Connect Short Hose Nut (11A) onto Water Supply Valve (11B). Turn on Water Supply
Valve (11B) by turning Handle (11E) counterclockwise. For E11W models only, connect
Short Hose Nut (11A) onto Water Supply Valve (11B).
12 INTERNAL PLUMBING
Tank comes pre-installed with fl ushing mechanism. (Some adjustments may be
necessary).
13 UNIT START UP
Turn on Main Water Supply Valve and check for leaks.
14 TANK LID INSTALLATION
Place Tank Lid (14A) on top of Tank (14B). Be sure Lid Lip (14C) covers the top of
Tank (14B).
15 FLUSHING
Press Flush Button (15A) to activate fl ushing mechanism. Flushing Button (15A) comes
with Full Flush (15B) and Reduced Flush (15C). Check for leaks above and below the
toilet.
16 SECURING TOILET BOWL
Secure Toilet Bowl (16A) to the fl oor surface by placing a bead of sealant around Toilet
Bowl Base (16B). (Sealant not included). Please follow manufacturer’s instructions
when using sealant.
4
10J
10H
10C
10D
10G
10E
10F
10A
10L
10K
10B
14A
14B
14C
15A
15B
15C
11E
11B
11A
11C
11D
16A
16B