En g l is h english, Ab c – Pfister VTP-E10W User Manual

Page 3

ENGLISH

ENGLISH

For E11W Models

Continue With Step 10

For E10W Models

GO To Step 11

8 OUTLET CONNECTOR INSTALLATION

A. Place Wax Seal 8A) fi rmly into groove on the base of Outlet Connector (8B) as shown.
B. Place Outlet Connector (8B) onto Waste Outlet Hole (8C) with Tee Bolts (8D) passing
through Fixing Holes (8E). Place Washers (8F) and Nuts (8G) into Tee Bolts (8D).
Secure Outlet Connector (8B) by tightening Nuts (8G).
C. Optional: For additional support, mark and drill a second set of Mounting Holes (8H)
and install Screws, Washers and Anchors (8J) that are provided.

9 TOILET BOWL INSTALLATION

A. Carefully set Toilet Bowl (9A) over Outlet Connector (9B) aligning the Bowl Outlet
Hole (9C) with Outlet Connector Hole (9D).
B. Place Plastic Washer (9E) and Screw (9F) into Hole (9G) located on the base of
Toilet Bowl. Secure by Tightening Screw (9F) until Toilet Bowl (9A) adheres to the
bracket inside fi xture. Place Decorative Cap (9H) over Plastic Washer (9E) as shown.

OPTIONAL