Pfister VTP-E30W - Manual (Page 5)

E
N
G
L
IS
H
ENGLISH
ENGLISH
16 TOILET SEAT COVER INSTALLATION
A. From below Toilet Bowl (16A), insert Anchor Nuts (16B) into Seat Post Holes (16C).
From above Toilet Bowl (16A), place Hinge (16D) over Seat Post Holes (16C). Place
Washers (16E) over Hinge Holes (16F) and secure with Screws (16G) as shown.
B. Place and align Seat Cover Holes (16H) and Seat Holes (16J) with Hinge Posts
Holes (16K). Insert Stud Posts (16L) and Plastic Rods (16M) into Hinge Posts Holes
(16K) as shown. Place Lock Cover (16N) onto the ends of Stud Posts (16L) as shown.
C. Place Hinge covers (16P) over Hinge Posts (16Q) as shown.
MAINTENANCE & CARE
DISASSEMBLY:
1. Replacement parts may be available at the store where you purchased
your toilet.
2. When replacement parts are not available, please write or call Price Pfi ster
Consumer Service.
3. Always turn off water and relieve pressure before working on your
toilet.
CARE:
Cleaning Instructions:
Use only a soft damp cloth or sponge to clean and shine. Use mild detergent,
liquid dish washing soap or warm water for cleaning. Read the cleaner product
label before using. Use of polish, detergents, abrasive cleaners, organic
solvents or acid may cause damage. The use of in-tank cleaners or products
containing calcium hypochlorite can damage fi ttings in the tank. Use of other
than a soft damp cloth or sponge will nullify our warranty!
Special Trim:
Trim products which contain Porcelain, or other similar substance, are like
fi ne jewelry and should be cleaned with warm water. Installation of Said Trim
is at Users Risk!
For more information about the installation or care and warranty information,
please contact your local Black & Decker HHI representative in your country
or visit www.pricepfi ster.com/international
5