beautypg.com

Pfister E42-BNFC User Manual

Page 2

background image

Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to provide long trouble-free use
under normal conditions. This faucet is easy to install using basic tools and our easy to follow illustrated instructions. If you have any questions regarding
this product, contact your local distributor.

1 BEFORE PROCEEDING:

WARNING: Read all the instructions completely before proceeding.

Price Pfister recommends calling a professional if you are uncertain
about installing this product!

This product should be installed in accordance with all local and state

plumbing and building codes.

2 WATER SHUT-OFF:

2

Locate water supply inlets and shut off the water supply valves. These

are usually found near the water meter.

3 SURFACE PREPARATION:

For optimum performance of your new Price Pfister Single Control

Lavatory faucet, a minimum water pressure of 20 PSI [137.89

KPascal] is required. Have the basic tools ready for removal of old

valve. If you are replacing an existing faucet, disconnect the old one

and clean the mounting surface thoroughly.

4 TOOLS RECOMMENDED:
For Iron Pipe Installation:

• Phillips Screwdriver • Adjustable wrench • Pipe Wrench

• PTFE Plumbers Tape

• Thread Sealant

• Slotted screwdriver

Some additional tools may be required.

5 INSTALLING THE FAUCET

Insert O-Ring (5B) through the Faucet Supply Tubes (5A). Insert

Faucet Supply Tubes (5A) and O-Ring (5B) through the hole in sink
(5D). Align the Faucet Body (5C) to desired position.

6 SECURING THE FAUCET

From underneath sink, feed O-Ring (6A) and Clamp Washer (6B) over

the supply tubes (6C) and Clamp Screws (6D). Tread the Clamp Nuts

(6E) on the Clamp Screws (6D) until faucet is firmly secured to the sink
(6F).

7

5

6

7 CONNECTING WATER SUPPLY LINES

Connect hot Water Supply Line (7A) to hot Inlet fitting (7B) indicated

by red flag. Be sure to hold faucet inlet fitting (7B) steady while

tightening the supply line. Wrench tighten until seal is achieved.
Repeat for cold Water Supply (7C).

Model E42-ANFC is shown.

2

ENGLISH

5B

5A

6A

7B

7C

5D

5C

6C

6D

6B

6C

6E

6F

7A

6E

6D

6B

6E

6F

This manual is related to the following products: