Pfister 8P5-CS1C - Manual (Page 5)

5
to remove Valve Cartridge and other Plastic Components
from the Valve Body before soldering. Use copper pipe
adapters (not furnished) in this type of installation.
6 TRIM FLANGE ATTACHMENT (Fig.C)
Position trim flange (1) with Rubber Gasket (2) onto the
valve body (3) and slide flush to wall finish. Secure with
Ring (4) onto valve body.
7 HANDLE ATTACHMENT (Fig.D)
Place Handle Hub (1) on Valve Stem (2) with O-Ring (3)
and secure with Set Screw (4) (do not over tighten). Install
Decorative Cap (5). To remove handle reverse steps.
8 VALVE FUNCTION (Fig.E)
By lifting the Lever Handle (1) up, the valve will be activated
allowing water to flow. The water flow will increase by
continuing to lift up the Lever Handle (1). By rotating the
Lever Handle counter-clockwise, the water temperature will
decrease to cold flow only. By rotating the Lever Handle
clockwise, the water temperature will increased to hot flow
only.
9 SHOWER ARM AND SHOWER HEAD
INSTALLATION (Fig.F)
For shower only products: Insert the end of Shower Arm (1)
through the Shower Flange (2). Apply PTFE plumber's tape
to both ends of Shower Arm (1) according to manufacturer's
instructions. Screw the long end of Shower Arm (1) into pipe
(3) elbow inside the wall. Slide Shower Flange (2) tight to
the wall. Screw the shower head (4) to the Shower Arm (1),
placing the Washer (5) in between.
1
4
2
3
C
1
2
3
4
5
D
1
OPEN
COLD
HOT
E
K
1
5
4
2
3
F