Pfister 8P5-CS1C - Manual (Page 4)

4
Thank you for purchasing this Price Pfister product. All Price
Pfister products are carefully engineered, and factory tested
to provide long trouble-free use under normal conditions.
This product is easy to install using basic tools and our easy
to follow illustrated instructions. If you have any questions
regarding this product, see info on previous page.
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before
proceeding. Price Pfister recommends calling a professional
if you are uncertain about installing this product!
This product should be installed in accordance with all local
and state plumbing and building codes.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply
valves. These are usually found under the sink or near the
water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface
thoroughly.
3 ASSEMBLY INSTRUCTIONS
If operating pressures exceed 5 BAR (~75 PSI), the use
of a pressure reducer is recommended. Before proceeding
with the assembling, we advise to clean the hot and cold
water tubes, in order to avoid build-up of dirt that could
compromise the functioning of the valve.
4 VALVE INSTALLATION (Fig.A)
For Center Hole (1) on plaster wall, use the edges from
Plaster Guard (2) to inscribe Cutting Edges (3). Cut Center
Hole (1) along inscribed lines, as shown. The Depth is
measured from center of Valve Body (4) to finished wall
surface (5) is 1" min. to 2" max. The tub spout and shower
outlet holes on the wall are to be 1 1/4" diameter.
5 VALVE INSTALLATION (Fig.B)
Place the Valve Body (1) into the wall, with the Shower
Outlet (2) facing the up. Body inlets (3&4) and outlet (2) are
designed to accommodate 1/2-14 NPT pipe. Connect the
Hot Water Supply (3) to the Left Inlet and the Cold Water
Supply (4) to the Right Inlet. Connect Shower (5) and Tub
(6) Outlet Pipes to Valve Body (1). Connect Pipe Elbows (7)
(not included) to ends of both pipes.
For Shower only products, Plug tub outlet (bottom valve
outlet) with pipe plug (8) For tub only products, plug shower
outlet (Top valve outlet) with pipe plug (8)
WARNING: When attaching threaded fittings, use thread
sealant or PTFE Plumber’s tape according to manufacturer’s
instructions.
CAUTION: When using iron pipes, it is not recommended
to reduce outlet pipe diameter.
CAUTION: For Copper Sweat joints, it is important
Supply Suggested Maximum Minimum
Hot Water
Temperature
65 Cº (150ºF) 80 Cº (175ºF) 15 Cº (60ºF)
Operating
Pressure
3 BAR (44PSI) 5 BAR (73PSI) 0.5 BAR (7PSI)
ENGLISH
1 1/4” DIA. Hole
1 1/4” DIA. Hole
1” Min. to 2“ Max.
1
5
2
3
4
A
1
3
8
5
7
7
4
6
2
B