Pfister 042-CNFC/042-CNFCA - Manual (Page 4)

4
Thank you for purchasing this Price Pfister product. All Price
Pfister products are carefully engineered, and factory tested
to provide long trouble-free use under normal conditions.
This product is easy to install using basic tools and our easy
to follow illustrated instructions. If you have any questions
regarding this product, see info on previous page.
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before
proceeding. Price Pfister recommends calling a professional
if you are uncertain about installing this product!
This product should be installed in accordance with all local
and state plumbing and building codes.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply
valves. These are usually found under the sink or near the
water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface
thoroughly.
3 ASSEMBLY INSTRUCTIONS
If operating pressures exceed 5 BAR (75 PSI), the use of
a pressure reducer is recommended. Before proceeding
with the assembling, we advise to clean the hot and cold
water tubes, in order to avoid build-up of dirt that could
compromise the functioning of the faucet.
ENGLISH
4 INSTALLING FAUCET (Fig.A)
Insert Lift Rod (1) into hole at the back of Faucet Body (2).
Ensure that Seal Base (5) is pressed onto Spout Base (4).
Place Spout Base (4) and Seal Base (5) onto the bottom of
Faucet Body (2). From above sink, insert Faucet Supply
Tubes (9) and Threaded Shank (3) through Hole on the sink.
From underneath sink, secure Faucet Body (2) by placing
Rubber Washer (6), Metal Washer (7) and threading Nut (8)
onto Threaded Shank (3). For thin decks use Flange (20)
instead of Washers (6 & 7) to secure Faucet.
Caution: Do not over tighten!
5 DRAIN BODY INSTALLATION (Fig.A)
The Flange (17) can be installed with or without Rubber
Seal (10). If Drain Flange (17) is installed without Rubber
Seal, Apply a small bead of plumber’s putty underneath
the Drain Flange (17) and around Drain Opening (18).
Insert Drain Flange (17) into Drain Opening (18). From
underneath, slide Rubber Washer (11) onto the bottom
of Drain Flange (17). Thread Locknut (12) until Rubber
Washer (11) seats securely inside Drain Opening (18).
Remove excess plumber’s putty. Adjust Drain Body so that
the Ball Rod Opening (15) faces the rear.
Drop Stopper (16) into Flange
(17). Place Nut (19) onto Ball Rod
(13). Insert the Ball Rod (13) into
the Ball Rod Opening (15) through
the Stopper Hole (16) and secure
with Nut (19). Place one end of
Spring Clip (14) onto the end of
Ball Rod (13). Insert Ball Rod (13)
into Clip (14). Be sure to leave
enough space between Lift Rod
(13) and Spout Body (2) when Lift
Rod is down. NOTE: Your model
may have an alternate drain body
assembly (see fig. A2).
Supply Suggested Maximum Minimum
Hot Water
Temperature
65 Cº (150ºF) 80 Cº (175ºF) 15 Cº (60ºF)
Operating
Pressure
3 BAR (44PSI) 5 BAR (73PSI) 0.5 BAR (7PSI)
A
2
1
4
3
5
6
7
8
9
20
16
11
12
15
18
19
10
17
13 14
A2