Pfister GT526-TMS - Manual (Page 5)

E
N
G
L
IS
H
ENGLISH
ENGLISH
MAINTENANCE & CARE
20
21
17
18
19
22
17 PULL-OUT OPERATION
The Pull-Out Hose (17A) can be pulled forward to spray water in any direction.
18 SPRAY OPERATION
To activate the spray mode, simply press Toggle Button (18A) located under the spray
head. You can change between spray and stream by pressing the opposite sides of the
Toggle Button (18A/18B) while the faucet is in operation. The water fl ow will increase
by sliding Spray Selector Switch (18C) from side to side.
Note: The faucet will always turn on in regular stream mode.
19 SOAP DISPENSER OPERATION
To activate Soap Dispenser (19A), press Dispenser Head (19B) to spray liquid soap.
20 SPRAY HEAD REMOVAL
To prevent damage to the internal parts of your faucet from debris that may have collected
in the water lines, it will be necessary to fl ush the faucet. Flushing requires the removal
of the spray Head (20A). To remove the Spray Head (20A), hold metal Hose Fitting
(20B) and turn the Spray Head (20A) counterclockwise.
21 FLUSHING
Lift the Valve Lever Handle (21A) up to the full on position. Run water for one minute.
Repeat in hot and cold positions. Reassemble the Spray Head (21B) to the Pull-Out
Hose (21C) by turning Spray Head (21B) clockwise.
Caution: do not over tighten spray head / pull-out hose.
22 AERATOR CLEANING
Over time, the aerator in your faucet may become clogged with debris. To clean the
aerator, unscrew Aerator Housing (22A) from Spray Head (22B). Remove Aerator Seal
(22C) and Aerator Cartridge (22D) from Aerator Housing (22A). Clean Aerator Cartridge
(22D) and Aerator Housing (22A).
5
17A
18A
19B
20A
21B
22A
18B
18C
19A
20B
XX 21A
21C
22B
22C
22D