Pfister GT529-MCS - Manual (Page 4)

ENGLISH
11
Water Supply Lines are not included. Please
consult manufacturer and/or its instructions for
the correct method of installation of supply lines
and fittings.
CAUTION: Incorrect application of supply lines and
fittings may result in the failure or leak of the supply lines
and fittings.
12
13
11 WATER SUPPLY CONNECTIONS
A.Thread inlet connectors (11A) into Water Supply Lines (11B).
B.Remove Protective Cap (11F). Gently separate HOT and COLD Faucet Inlets (11C),
approximately 1 in. (26 mm) apart. Connect Water Supply Lines (11B) onto Faucet Inlets
(11C). Hot Water supply goes to hot inlet fitting indicated by red tag (11D).
C.Insert Clip (11E) into Inlet Connector Holes (11F) to secure water supply lines, as shown.
WARNING: Do not twist Faucet Inlets.
12 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink
13 FLUSHING
Remove Spray Head (13B) by turning it counterclockwise. By rotating the Lever Handle
(13A) away from the Faucet Body (13D), the valve will be activated allowing water to flow.
The water flow will increase by continuing to rotate the Lever Handle (13A). Run water for
one minute. Repeat in hot and cold positions. Reassemble the Spray Head (13B) to the
Hose (13C) by turning Spray Head (13B) clockwise.
Caution: do not over tighten spray head and hose.
4
HOT
1” Max.
(26 mm)
COLD
11C
11A
11C
11B
11E
11F
11A
11B
11B
11B
11B
11E
11A
11F
11D
11A
11C
A
B
C
13A
13D
13A
13C
13B
OPEN