Pfister GT529-MCS - Manual (Page 3)

ENGLISH
7
1 HOLE INSTALLATION
10
8
9
7 INSTALLING MOUNTING RING
Place Mounting Ring (7A) over Putty Ring (7B) and sink hole. Align Mounting Ring (7A) to
the center of sink hole. Place a bead of plumber’s putty in the bottom groove along the
outer edge of Putty Ring (7B).
8 BODY INSTALLATION
Insert Faucet Supply Tubes (8A) and Mounting Shank (8B) through the hole in Deckplate
(8C) or Mounting Ring (8D).
9 SECURING SPOUT BODY
From underneath sink, place Washers (9A), (9C) and Locknut (9B) over Hose (9H) and Supply
Tubes (9D). Thread loosely onto faucet shank (9E). Make sure that Handle (9F) is properly
aligned to sink. Tighten faucet firmly to sink, using the provided Installation Tool (9G).
10 HOSE ATTACHMENT
From underneath sink, push Hose Connector (10A) onto receiving Tube (10B). Push up
until unable to push any further. To remove Hose, press on the Tabs (10C) and pull Hose
Connector (10A) down.
3
7A
7B
9C
8C
10A
10A
10B
8B
8A
8B
8D
9B
9A
10C
9G
9E
9H
9F
8A
9D