Proface FP3900 - 19 Flat Panel" - Manual (Page 19)

19
„ Top Main
• In the OSD, pressing the button applies the set value and
enables the setting. The set value won’t be canceled unless the
power is turned OFF or the value is reset.
If the power is turned OFF without saving the set value, that data
will disappear. The last saved data will be read into the system
when the FP starts. To enable the changed value, be sure to press
the button.
• All the setting values, even though in process of the OSD settings,
will be retained in condition of letting the OSD leave more than 30
seconds or by pressing the button. The OSD will keep those
values and make them effective until power-off or a Reset
command input.
Selection of the change item
Applies the setting and then returns to the top menu.
Cancels the setting and then returns to the top menu.
Screen Settings
H.Position
V.Position
H.size
Phase
Display Clock
Contrast
R.Contrast
G.Contrast
B.Contrast
Brightness
Color Settings
Adjustment button
Selection of the change item
Adjustment button
Applies the setting and then returns to the top menu.
Cancels the setting and then returns to the top menu.
Custom Display
Sharpness
Dimmer
Auto Adjust Enable
OSD Transparent
Selection of the change item Adjustment button
Applies the setting and then returns to the top menu.
Cancels the setting and then returns to the top menu.
Clock for output to TFT-color display can be finely
adjusted according to 9 levels. (Default: 50)
Please use to the default value normaly.
(Analog RGB only)
(Analog RGB only)
(Analog RGB only)
(Analog RGB only)