Proface FP3900 - 19 Flat Panel" User Manual
Page 11

11
Serial Interface
Pin Assignments and Signal Names for Serial Interface
*1
The CD, DTR, and DSR are connected together inside of the FP.
Connector ..................... Dsub 9 pin female
Connector set screw ..... Inch type (#4-40UNC)
Cable............................. SIO cable for FP manufactured by Pro-face.
(FP61V-IS00-O)
Concerning Signal Names
Signal names used for the serial interface on FP units are designed to match the
pin order used on most PC serial interfaces, so that a straight cable can be used
to connect the two. Therefore, connect each pin’s signal to the same signal name
on the PC side.
For example, pin #2 ‘RD’ should be connected to the ‘RD’ input terminal on the
PC’s connector.
Refer to the FP3000 Series User Manual’s section “Cable Diagrams” for each
signal’s direction.
USB Interface (Type-B connector : Up-Stream Port)
Pin Assignments and Signal Names for USB Interface
Cable............................. USB cable manufactured by Pro-face.
(FP-US00)
RS-232C Serial Interface
Baud rate : 9600 bps
Data length : 8 bits
Parity : None
Stop bit : 1
Flow Control: None
Pin No. Signal Name
Condition
Pin Location
1
CD
Carrier Detect
*1
2
RD
Receive Data (FP->Host)
3
SD
Send Data (FP<-Host)
4
DTR
Data Terminal Ready
*1
5
GND
Ground
6
DSR
Data Set Ready
*1
7
RS
Request to Send (FP<-Host)
8
CS
Clear to Send (FP->Host)
9
NC
(Used internally)
Pin No.
Signal Name
Condition
Pin Location
1
USB1-5V
+5VIN
2
USBD1(-)
USB data(-)
3
USBD1(+)
USB data(+)
4
GND
Ground
• If a cable other than the specified USB cable is used, product
performance cannot be guaranteed due to the possibility of
noise interfering with the FP unit’s operation.
6
9
1
5
4
3
2
1