SaltDogg WB200B v.2 - Manual (Page 6)

6
TM
DRIVE WHEEL NOT
SHOWN FOR CLARITY
3
5
15
15
(4X) M6x40
WITH SMALL
WASHERS
(2X) M6x40
SPINNER
SHAFT
6. Use two m6x40 bolts to fasten the lower part of
the Hopper Support Brackets to the Frame. Position
the Spinner Shaft Straight and then using four m6x40
bolts with smaller washers, loosely assemble the
Hopper Assembly(3), the Deflector Assembly(5), and
the Hopper Support Brackets(15) to the Frame. The
Spinner Shaft will go through a hole in the bottom of
the Hopper Assembly.