AGFA 307 - Manual (Page 66)

Troubleshooting
Refer to these pages to determine the cause of a problem you are
experiencing with your camera. If the information does not cover the
problem which you are experiencing or the condition continues,
contact your nearest AGFA dealer.
No display appears when the camera is switched on
• Batteries are exhausted.
If the camera battery is exhausted, install a new battery. If the
lithium ion battery is exhausted, remove and recharge, or use the
AC power adapter.
Help and number of one or two figures appear in the data panel
• Camera operation malfunction.
Remove and reinstall the battery in the camera body. If normal
camera operation does not resume, contact cn AGFA dealer.
When contacting, tell the Service representative the
number that appears in the data panel.
Auto focus does not work when shutter-release button is pressed
partway down
• Situation is unsuitable for autofocus.
Use focus lock or manual focus.
• Camera is set to the manual focus mode.
Set to the auto focus mode by pressing the focus mode button.
• Subject is too close.
Check the minimum focus distance for your lens.
Shutter cannot be released
• Camera has not been set to the standby mode.
Check that the standby lamp in the viewfinder is lit before pressing
the shutter release.
• Focus cannot be confirmed.
Use focus lock, or manual focus.
• PC card has not been inserted yet.
Insert the AGFA ACTIONCAM Digital Film into the card slot
according to the instructions on page 10.
• Camera is attached to a microscope or telescope
Contact an AGFA dealer for information.
The Initial Load does not start after sliding the main switch to ON
• The PC card is not fully inserted into the card slot.